SIZE CHART

Bellabito Gown Guardian Wedding Dresses Protect Size Chart

HOW TO MEASURE

Your shapewear is determined by your waist and hip sizes.

WAIST SIZE

is taken by placing the tape measure snugly around the smallest part of your waist, following your body’s natural indentation. If you’re not sure where your smallest part is located, bend to the side to find it.

HIP SIZE

is taken, while standing with your legs together, by placing the tape measure around the fullest part of your hips. This should be approximately 7” below your waist.

LENGTH

is determined by measuring vertically from right below your chest down to the floor. This will allow you to see where the bottom of the garment will fall on you based on the style you choose.

*Length measurements are taken from the top hem of the shapewear to the lowest point of the satin in the front and back to include the entire length of the garment.*

HOW TO WEAR

We suggest gathering the shapewear in your hands until your fingers touch the satin and then step into the Gown Guardian, slowly pulling the shapewear up to the desired location on your torso.  (We recommend placing the top hem right below your chest for the most comfortable fit.)

*ADDITIONAL INFORMATION

  • Length measurements are taken from the top hem of the shapewear to the lowest point of the satin at the bottom to include the entire length of the garment.
  • The product does not vary in length based on size, so the length for each style is a general standard no matter the size garment.

**Your safety is a high priority so please ensure the length will not be a problem for you before you order!**

Pin It on Pinterest